Tweet
Name: Phil
Location (City, State): Saint Albans, VT
Means of Contact: Post or PM for Phone #
Description: See Below
Price: 1,300
My wife (and I) REALLY wanna move out of our condo sooner then later... so I have to sell sell sell!
This bike is a project... I have lots of spare parts... I can't even name all the spare parts... Parts are a mismash of EXC parts and SX parts:
Off the top of my head:
-1 Gas tank (one for EXC)
-1 seat (Has black duct tape cover fits exc tank) seat installed is off the SX
-1 extra seat cover (fits either)
-2 fork sets (1 set completely apart <older style>, 1 set inverted SX... worth a pretty penny)... all forks need new seals (have new seals for the older EXC forks)
-1 extra frame (could use some paint)
-2? extra front fenders
-2 extra rear fenders
-extra brake assembly (brembo baby!)
-Wheel bearings (new)
-Kill switch (new)
-front tube (new
-rear tube (new)
-fork boots (new)
-grips (new)
-fork seals (not installed)
-Exhaust repacked (gross and took forever)
-front axle (used)
-front rim (used)
-front spokes(new)
-air filter (new)
-exhaust springs (new)
-clutch line (used)
-clutch lever (new)
i'll include the helmet I got too. it's a little to small for me anyways... wore it once just to try it on... I don't have lice.
Engine has been turned over before I disassembled it and it ran nice for the few seconds it was running. new seals in the engine and tranmission make me believe the PO wasn't fibbing when he said had it all rebuilt prior to storage. they look brand spanking new. I do think however the transfer case might have a chip in it and he sealed it with a ishton of red high temp rtv... I am not going to check, you can when you take it home :-P I also think he added a first gear from an MXC bike which makes first really low ratio... I dunno though... he told me he geared down first gear when he had it rebuilt.
Looking for $1300 for everything. take it all! show up with a truck please... we could stuff everything in the back I think.
Pictures:
Location (City, State): Saint Albans, VT
Means of Contact: Post or PM for Phone #
Description: See Below
Price: 1,300
My wife (and I) REALLY wanna move out of our condo sooner then later... so I have to sell sell sell!
This bike is a project... I have lots of spare parts... I can't even name all the spare parts... Parts are a mismash of EXC parts and SX parts:
Off the top of my head:
-1 Gas tank (one for EXC)
-1 seat (Has black duct tape cover fits exc tank) seat installed is off the SX
-1 extra seat cover (fits either)
-2 fork sets (1 set completely apart <older style>, 1 set inverted SX... worth a pretty penny)... all forks need new seals (have new seals for the older EXC forks)
-1 extra frame (could use some paint)
-2? extra front fenders
-2 extra rear fenders
-extra brake assembly (brembo baby!)
-Wheel bearings (new)
-Kill switch (new)
-front tube (new
-rear tube (new)
-fork boots (new)
-grips (new)
-fork seals (not installed)
-Exhaust repacked (gross and took forever)
-front axle (used)
-front rim (used)
-front spokes(new)
-air filter (new)
-exhaust springs (new)
-clutch line (used)
-clutch lever (new)
i'll include the helmet I got too. it's a little to small for me anyways... wore it once just to try it on... I don't have lice.
Engine has been turned over before I disassembled it and it ran nice for the few seconds it was running. new seals in the engine and tranmission make me believe the PO wasn't fibbing when he said had it all rebuilt prior to storage. they look brand spanking new. I do think however the transfer case might have a chip in it and he sealed it with a ishton of red high temp rtv... I am not going to check, you can when you take it home :-P I also think he added a first gear from an MXC bike which makes first really low ratio... I dunno though... he told me he geared down first gear when he had it rebuilt.
Looking for $1300 for everything. take it all! show up with a truck please... we could stuff everything in the back I think.
Pictures:
Anti-Speedbump Society 
Comment