No Holes License Plate options

[KeiserX13]

Should be all you need , 2 screws go into the bumper and the back screw goes into a bracket you mount to the frame or something .

i just use 2 screws in my lip and not the rear metal strap, has worked fine for a few years

[Boosted Euro]

this is what i have

i just use 2 screws in my lip and not the rear metal strap, has worked fine for a few years

Nice, I new someone had one. I was wondering if it would work with just the fronts, i thought it would.

[polarisman14]

I just cut up my factory mount and drilled holes through the bottom of the bumper to mount it rather than the front of it. Using some large fender washers on the backside helps keeping the weight from pulling it down, and with the duct right behind it I could rig up a bracket to hold the top in place if it becomes an issue. I could have also fabbed up some metal brackets, welded some nuts to the underside of the metal bumper support, and bolted it on...This was just way easier.



That's the best picture I have of it mounted up, it's basically an almost-90-degree bracket that's about 4" wide and each "leg" of it is probably 6 inches long.