Looking for a Haltech tuner

[jsann]

Kaizen, said no because they are not too familiar with the 2JZ platform and referred me to Alex.

[mike cm]

Kaizen.... only if own a GTR... then again I won't say anymore. I have my reasons lol. Good luck in your ventures.

[OVRBST]

Sorry brother, I just don't do the real old stuff. E11 and newer, and even at that I'd rather not do an e11. That old stuff requires old laptops, old software and older hardware. I don't have most of that anymore. Hell, the old Haltech stuff won't even run on new computers.

Sorry man. Call around, someone may still do them.

[Th3Juggernaut]

and got married

well sh*t there's your solution, ditch her and spend the money you save on the new AEM. there are priorities in life dammit

[Graffix]

Kaizen.... only if own a GTR... then again I won't say anymore. I have my reasons lol. Good luck in your ventures.

We work on far more than gtr's

[jsann]

Sorry brother, I just don't do the real old stuff. E11 and newer, and even at that I'd rather not do an e11. That old stuff requires old laptops, old software and older hardware. I don't have most of that anymore. Hell, the old Haltech stuff won't even run on new computers.

Sorry man. Call around, someone may still do them.

I completely understand. Ill be honest, you were highly recommended by many and still on the top of my list. I have decided to go the AEM v2 route. Since AEM never made a box specifically for the vvti motors, I will be doing some modding on the 30-6050 box with a custom harness. The only problem I forsee is the calibration for the sensors I would be using (mainly all GM sensor). Since I am not too familiar with these units are you able to setup the calibration?


P.s The I am runnig the older Halwin software on my Window 7 64 bit. Its a little complicated because you have to run an additional operating system on a virtual machine setup. I have it setup on my newer laptop.

[gtmustang00]

We work on far more than gtr's

We? YOU don't! Don't you just sit in the office?

[Graffix]

We? YOU don't! Don't you just sit in the office?

cool story bro...pretty sure I work here

[g96nt]

Call Dave @ ESP.
I recommended them in your other thread, too.
Great guys, good rates, and strong reputation.